Emerson CF452ORB00 Install, Operate and Maintain Your Ceiling Fan, Tools Needed for Assembly

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One wire stripper
Three wire connectors (supplied)

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 8). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the bottom of the motor facing up.

The upper foam pad serves as a holder for the fan during the first stages of assembly.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description,	BLADES
refer to exploded view illustration.

a. Fan motor assembly
b. One switch housing assembly
c. One ceiling cover
d. Five blade flanges		LOOSE PARTS
e. One hanger ball/4.5” downrod assembly		BAG	FAN MOTOR
f. One hanger bracket		BLADE	ASSEMBLY
g. One coupling cover		FLANGES
h. Five fan blades
i. One loose parts bag containing:
1.	Sixteen M5 x 6mm washer head		SWITCH HOUSING
	blade screws		ASSEMBLY
2.	One M4 x 12mm flat head screw
3.	One M6 x 14mm pan head screw with		HANGER BALL/
	lockwasher		DOWNROD ASSEMBLY
4.	One die-cast pendant		HANGER
5.	One pendant coupler
		CEILING	BRACKET
6.	Three wire connectors	COVER
7.	Two threaded studs		COUPLING
8.	Two knurled knobs
			COVER

9.Two lockwashers

10.One clevis pin

11.One hairpin clip

12. One balance kit 3 U.L. Model No.: CF452