Emerson CF452BS00, CF452GES00 How to Wire Your Ceiling Fan, Two knurled knobs supplied. Figure

How to Wire Your Ceiling Fan

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.

! WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before attempting installation.

NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.

1.Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation). Securely connect wires with wire connectors supplied.

! WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

3.	Screw the two threaded studs (supplied) into the
	tapped holes in the hanger bracket.
4.	Lift the ceiling cover up to the threaded studs and
	turn until studs protrude through the holes in the
	ceiling cover (Figure 14).
5.	Secure the ceiling cover in place by sliding
	lockwashers over the threaded studs and installing
	the two knurled knobs (supplied). (Figure 14).
	Tighten the knurled knobs securely until the ceiling

GROUND

WIRE

LISTED

BLACK AND BLUE FAN WIRES

cover fits snugly against the ceiling and the hole in

the ceiling cover is clear of the downrod. Your fan

is now wired to be turned on and off from the fan

switch.

WIRE

CONNECTOR (3)

GREEN WIRE (GROUND) FROM HANGER BRACKET

GREEN WIRE (GROUND) FROM HANGER BALL

WHITE SUPPLY (NEUTRAL)

WHITE FAN

WIRE

BLACK SUPPLY (HOT)

CEILING COVER

	NOTE: CEILING COVER
Figure 13
	OMITTED FOR CLARITY.

NOTE: If you are using an Emerson Light Fixture with your fan, see Light Fixture Owner’s Manual for wiring.

2.Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied (Figure 13). Securely connect the fan motor black wire and blue wire to the supply black (hot) wire using wire connector supplied (Figure 13). After connections have been made, turn leads upward and carefully push leads into the outlet box, with the green equipment-grounding conductor and white grounded neutral conductor on one side of the outlet box and the black and blue ungrounded conductors on the other side of the outlet box.

THREADED	LOCKWASHERS
STUDS (2)	(2)

KNURLED

KNOBS (2)

Figure 14

! WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

6.Cut the 3-speed switch pull chain to a desired length (optional). Connect the die-cast pendant (supplied) to the 3-speed switch pull chain by sliding the die-cast pendant (small hole first) onto the pull chain. Attach the chain coupling to the end of the chain and allow the die-cast pendant to fall down over the coupling.

8 U.L. Model No.: CF452