How to Put Your Ceiling Fan Together (continued)
6.Install the setscrew (supplied in loose parts bag) in the motor coupling and tighten using the 5/32" setscrew wrench (supplied) (Figure 3).
7.Screw two 1” threaded studs (provided) into the motor (Figure 4). Leave approximately 7/8” of the stud extending above the motor. Slide the motor cover over the downrod and rotate the cover until the threaded studs protrude; install two knurled knobs (supplied) to secure the cover.
NOTE: Make sure the red and brown leads are capped with wire connectors. Make sure the red, brown, and yellow wires and wire connectors are completely inside motor coupling cover and not pinched between the motor coupling cover and motor.
DOWNROD
SETSCREW
Figure 3
8.Position the ceiling cover over the downrod. Be sure the cover is oriented correctly, with the large opening at the top (Figure 5).
9.Reinstall the hanger ball on the downrod as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod (Figure 5). Install the pin through the holes at the top of the downrod and slide the hanger ball up the downrod, aligning the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
!
WARNING
WIRE
CONNECTORS
RED LEAD
BROWN LEAD 
MOTOR
KNURLED KNOB
MOTOR
COUPLING
COVER
WIRE CONNECTOR
YELLOW LEADS
1" THREADED STUD
7/8"
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
10.The blue, black and white leads exiting the downrod are
Figure 4
PIN
HANGER BALL
DOWNROD
SETSCREW
CEILING COVER 
Figure 5
5 | U.L. Model No.: CF4801 and CF4501 |
