Emerson CF712SCB01, CF712WW01, CF712BS01 Installing The Ceiling Cover On The Fan Motor Housing

Installing The Ceiling Cover On The Fan Motor Housing

(For Close-to-the-Ceiling Mounting)

1.Remove and retain three screws from the top of the motor housing (Figure 3A).

2.Position the rubber gasket (supplied in parts bag) on the motor housing (small holes in gasket centered over the screw holes in the housing) (Figure 3B).

REMOVE SCREWS (3)	INSTALL GASKET
Figure 3A	Figure 3B

3.Gently pry the decorative cap (Figure 2) from the ceiling cover. Align the holes in the ceiling cover with the holes in the motor housing and secure using the three screws (Figure 4).

RUBBER	SCREW (3)
GASKET

Figure 4

4.The fan comes with blue, black and white leads that are 42” long. Measure up approximately 6 to 9-inches above the motor coupling. Cut off excess leads and strip back insulation 1/2-inch from ends of leads.

Installing The

Hanger Bracket

!WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 5).

7'

MIN.

Figure 5 FLOOR

!WARNING

The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”.

1.Unscrew (but do not remove) the two mounting screws in the outlet box (Figure 6). Position the hanger bracket on the outlet box so that the T-slots in the hanger bracket are aligned with the outlet box screws.

	OUTLET BOX
	LOOSEN TWO
T-SLOT	SCREWS (SUPPLIED
	WITH OUTLET BOX)

SLIDE THE HANGER

BRACKET ONTO

THE OUTLET BOX

SCREWS, THROUGH

THE T-SLOT

HANGER

BRACKET

Figure 6

!WARNING

To reduce the risk of fire, electrical shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

NOTE: The hanger bracket must be mounted flush with the ceiling in order for the ceiling cover to install properly. If necessary, use leveling washers (not supplied) between the outlet box and the hanger bracket.

2.Slide the hanger bracket onto the outlet box screws. Center the bracket over the outlet box and then securely tighten the screws (Figure 7).

!WARNING

Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, use leveling washers between the hanger bracket and the outlet box until the bracket is flush with the ceiling. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.

		SECURELY
		TIGHTEN
	HOOK	SCREWS
	Figure 7	HANGER BRACKET
5		U.L. Model No.: CF712