Emerson CF875 Tools Needed for Assembly, Materials, Unpacking Instructions, Installed Wire Length

This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver One 1/4" blade screwdriver One stepladder

One wire stripper

Four 60-watt (maximum) intermediate base bulbs Four 7-watt (maximum) candelabra base bulbs

MATERIALS

Wiring, electrical box and box connectors must be of type required by local code. The minimum wire would be a 3-conductor (2-wire with ground) of size shown at right.

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50 - 100 ft.	12

!WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 5). If you feel you do not have enough wiring knowledge or experi- ence, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provide next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or acces- sories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Check to see that you have received the following parts:

a.Crystal glass housing

b.Mounting plate/light fitter

c.Motor assembly

d.Switch housing/light fitter

e.Four glass shades

f.Five fan blades

g.Five blade flanges

h.One loose parts bag containing:

1.Fifteen 3/16-24 x 9/32" phillips head screws.

2.Ten 1/3-20 x 1/2” phillips head screws.

3.One wood ball (small) with chain.

4.One wood ball (large) with chain.

5.Three wire connectors.

6.Four 3/16-24 x 3/8" phillips head screws.

7.Three wire connectors

8.Four Nuts-Hexlock 1/4-20.

NOTE: Place the parts from the loose parts bag in a small container to keep them from being lost. If any parts are missing, contact your local retail or catalog outlet for replacement before proceeding.

3