Emerson CF875 warranty How To Wire Your Ceiling Fan, How To Put Your Ceiling Fan Together, 5Figure

How To Wire Your Ceiling Fan

If you feel that you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

!WARNING

To avoid possible electrical shock be sure electricity is turned off at the main fuse box or circuit breaker before wiring.

NOTE: If you are not sure if the outlet box is ground- ed, contact a licensed electrician for advise for it must be grounded for safe operation.

1.Connect the green grounding wire from the motor bracket and the green wire from the mounting plate/light fitter to the grounding conductor of sup- ply (this may be a bare wire or wire with green col- ored insulation). Securely connect wires with wire connector supplied. (Figure 5.)

		120V SUPPLY
	GROUND	WHTIE
		BLACK
	WHITE
GREEN GROUND		BLUE
		BLACK

ORANGEWHITE

2. Securely connect the motor orange wire to the mounting plate/light fitter orange wire using wire connector supplied. (Figure 5).

3. Securely connect the fan motor white wire and the mounting plate/light fitter white wire to the supply white (neutral) wire using wire connector supplied. (Figure 5).

4. Connect the fan motor black wire and blue wire to the supply black (hot) wire using wire connector supplied. (Figure 5). Your fan is now wired to be turned on and off from the fan switch. After connec- tions have been made, turn leads upward and care- fully push leads up into the outlet box.

!WARNING

To avoid risk of fire or shock check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

5. Return to Step 3 of section "HOW TO HANG YOUR CEILING FAN".

Figure 5

How To Put Your Ceiling Fan Together

1.Screw four 7-watt 120 volt light bulbs into the sock- ets on the mounting plate/light fitter.

2.Install two 3/16-24 x 3/8” screws (several turns) into screw holes on opposite sides of the mounting plate/light fitter (Figure 6). Position the crystal glass housing so that the keyhole slots in the crystal glass housing engage with the two screws. Turn the housing to the right so the keyhole slots rest on the screws; tighten the screws. Install the other two 3/16-24 x 3/8” screws.

3. Mount the blade flanges to the fan blades using three 3/16-24 x 9/32” screws per blade (Figure 7). Repeat for four remaining blades.

!WARNING

To reduce the risk of personal injury, do not bend the blade flanges when installing the flanges, balancing the blades, or cleaning the fan.

KEYHOLE SLOT

3/16-24 x 3/8"

SCREW

CRYSTAL

GLASS

HOUSING

Figure 6

5Figure 7

(3) 3/16-24 x 9/32" SCREWS

BLADE

FLANGE

FAN BLADE