Emerson CF901BS00, CF901ORB00, CF901CK00, CF901VNB00, CF901GES00 Unpacking Instructions, Materials

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 10). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One switch housing assembly

c.Five fan blades

d.One ceiling cover

e.Five blade flanges

f.One hanger ball/downrod assembly

g.One hanger bracket

h.One coupling cover

i.One 4-speed fan speed control

j.One loose parts bag containing:

1.Sixteen #10-24 x 7mm washer head blade screws

2.One 1/4-20 x 14 captive screw with lockwasher

3.One #8-32 x 8mm pan head screw

4.Three wire connectors

5.Two threaded studs

6.Two knurled knobs

7.Two lockwashers

8.One clevis pin

9.One hairpin clip

10.One balancing kit

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the bottom of the motor facing up.

The upper foam pad serves as a holder for the fan during the first stages of assembly.

	j. LOOSE
	PARTS
	BAG	a. FAN MOTOR
		ASSEMBLY
		f. HANGER BALL/	g. HANGER
			BRACKET
		DOWNROD
		ASSEMBLY
	e. BLADE		b. SWITCH
	FLANGES		HOUSING
			ASSEMBLY
		h. COUPLING
		COVER	4
			3
			2
			1
		i. WALL	0
d. CEILING		i. FAN SPEED
		CONTROL
COVER		CONTROL
			c. FAN
			BLADES

3 U.L. Model No.: CF901