Emerson CF901ORB00, CF901CK00, CF901VNB00, CF901BS00 PIN Hanger Ball Ceiling Cover Coupling Cover

How to Put Your Ceiling Fan Together (continued)

3.Make sure the grommet is properly installed in the coupling cover, then slide the coupling cover on the downrod until it rests on the motor housing. Place the ceiling cover over the downrod. Be sure that the ceiling cover and the coupling cover are both oriented correctly (Figure 3).

4.Reinstall the hanger ball (Figure 3) on the downrod as follows. Route the three 80” motor leads through the hanger ball. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.

! WARNING

It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

5.The fan comes with blue, black and white leads that are 80” long. Before installing fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

6.Carefully turn the partially assembled ceiling fan over and set it on the shipping styrofoam for blade installation.

7.Remove the shipping spacers and the spacer attachment screws from the motor before installation of blade assemblies. Discard the spacers and spacer screws (Figure 4).

8.Mount blade flanges to fan blades using three #10-24 x 7mm washer head blade screws (Figure 5).

NOTE: Take care not to scratch fan housing when installing blades.

NOTE: Remove and discard the four shipping spacers and screws from the motor hub.

9.Loosely attach one blade assembly to the motor hub using the two 1/4-20 x 14 captive screws with lockwashers. Make sure the screws are NOT tightened. (Figure 6.) Repeat this procedure for other four blade assemblies.

10.The blade flanges have an interlocking feature that must be fully engaged before tightening the screw. Make sure all the flanges are properly engaged and then tighten the flange screws. If one of the flanges does not seat properly on the motor hub, loosen the adjacent flange screws, re-engage and reseat the flanges, then tighten the screws again.

DOWNROD SETSCREW

PIN

HANGER

BALL

CEILING

COVER

COUPLING COVER

Figure 3

SHIPPING SPACERS

AND SCREWS

SWITCH HOUSING

MOUNTING PLATE SCREW (4)

Figure 4

#10-24 x 7mm WASHER

HEAD BLADE SCREW (3)

FAN BLADE

BLADE FLANGE

Figure 5

CAPTIVE SCREW

LOCKWASHER

SWITCH HOUSING

MOUNTING PLATE HOLE

BLADE FLANGE

ASSEMBLY

Figure 6

5 U.L. Model No.: CF901