SUPPLY | BLACK AND BLUE | |
FAN WIRES | ||
GROUND | ||
| ||
WIRE |
| |
LISTED |
| |
WIRE |
| |
CONNECTOR (3) |
|
GREEN WIRE (GROUND) FROM HANGER BRACKET
GREEN WIRE (GROUND) FROM HANGER BALL
Figure 12
WHITE SUPPLY (NEUTRAL)
WHITE FAN
WIRE
BLACK SUPPLY (HOT)
NOTE: CEILING COVER OMITTED FOR CLARITY.
Using Your Ceiling Fan
1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.
2.Check the operation of the fan by gently pulling on the pull chain switch.
3.All fans are shipped from the factory with the reversing switch positioned to circulate air down- ward. If airflow is desired in opposite direction, turn your fan off and wait for the blades to stop turning, then slide the reversing switch to opposite position, and turn fan on again. The fan blades will turn in the opposite direction and reverse the airflow.
!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
3.Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket.
4.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 13).
5.Secure the ceiling cover in place by sliding lockwashers over the threaded studs and installing the two knurled knobs (supplied). (Figure 13.) Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan
CEILING COVER
| LOCKWASHERS (2) |
THREADED STUD | |
KNURLED KNOB | |
Figure 13 | switch. |
|
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
6. Cut the
Your fan model is equipped with a
THREE-SPEED
1st
SPEED CONTROL | REVERSIBLE | |
SWITCH PULL CHAIN | ||
SWITCH | ||
|
Maintenance
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.
Abrasive cleaning agents are not required and should be avoided to prevent damage to finish.
!WARNING
Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock.
Accessories
1.Ceiling Fan Light Kits (see store or catalog).
2.Ceiling Fan/Light Controls (see store or catalog).
3.Downrod Extension Kits (see store or catalog).
!WARNING
The use of any other control not specifically approved for this fan could result in fire, shock and personal injury.
of the chain and allow the wooden pendant to fall down over the coupling.
7
!WARNING
This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or acces- sories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.