7

Installing the phoneInstalling the Handset Battery
2.
Plug one end of the telephone line cord into the TEL LINE jack on the back of the base
and the other end into a modular jack.
3. Plug the AC power converter into the electrical outlet and the DC connector into the
jack on the back of the base.
4. Place the handset in the base cradle. The charge/in use voice mail indicator turns on,
verifying the battery is charging.

Base station

1.
Choose an area near an electrical outlet and a telephone wall jack (RJ11C), and place
your cordless telephone on a level surface, such as a desktop or tabletop, or you may
mount it on the wall.
Modular phone wall jack
Main power outlet
Replace the
cover
Install the
battery pack

Setting the speaker volume

Press the button.
During a call you can adjust the volume from 1 to 5.

Muting the microphone

Press the button.
During a call you can switch your handset’s microphone off. The display shows .
To unmute press the again.

Redial

Your handset saves the last 3 dialed telephone numbers
Viewing/dialing telephone numbers
The handset is in idle state
Press the button repeatedly (if necessary) until the desired telephone number is
displayed.
Press the button. The phone number is being dialed.
When you press the button and hear the dialing tone, the very last dialed telephone
number is dialed by pressing the button.
VOLUME
MUTE
MUTE
REDIAL
REDIAL
TALK
TALK

16

TALK
TALK
TALK
TALK
MUTE MUTE
Basic operation

Answering a call

Press the button, to answer a call.

Making a call

Enter the phone number, using telephone key pad. Delete wrong characters by pressing
the button. Press and HOLD the button to delete entire entry.
Press the button , and the phone number is being dialed.
You can also press the button, and you will hear the dialing tone. The entered
number will be dialed immediately. It is not possible to correct wrong digits individually
using this dialing procedure.

Ending a call

Press the button or replace the handset in the base station.

Call timer

Your handset automatically times the duration of every call.

Activating handsfree

During a call operation you can switch On/Off the speaker.
Press the button. The appears in the display when the speaker is ON.
CID
Inserting the batteries
Open the battery compartment cover, install the battery and replace the batterycover.Attention: : Use only power adaptors and batteries supplied with thisproduct. To order a replacement please call customer support :1-877-768-9483 or online: www.emersonphones.com
Charging the batteries
Before the handset is used for the first time, insert it in the base station / charging station for at least 16 hours.The handset warms up during the charging process. This is normal anddoes not represent a risk. The battery status is shown on the display. When thebattery capacity is nearly exhausted, the battery symbol will flash in the display.End your call and place the handset into the base or charging station forcharging.After a short time, the battery symbol will appear to be fully charged but this isactually not the case. The battery capacity will decrease rapidly. We adviseyou to put the handset on the base unit for 12 hours so that it can berecharged completely.