OPERATING INSTRUCTIONS

NORMAL PLAYBACK

1.) Connect the headphones to the PHONES jack. Set the VOLUME control to a low level before you begin playback.

Set the FUNCTION switch to CD position.

2.) Slide the CD Door OPEN switch to the right to release the lock and open the CD Door.

To PHONES Jack

1

2

3.) Place your disc on the center spindle with the printed label side facing up. Press down gently near the center hole to make sure the disc is properly seated on the spindle.

4.) Close the door completely until it locks shut.

5.) Press the Play/Pause button. “45 SEC” followed by “00”appear in the display as the player reads the disc, then playback begins on Track 1. The Anti-Skip indicator comes on and the playing time shows in the display.

6.) Adjust the VOLUME and DBBS (Bass Boost) controls as desired.

7.) When all tracks have been played the player stops and the display shows the total tracks and playing time on the disc. After approximately 1 minute the power shuts off and the display goes blank.

To stop playback before the disc ends press the Stop button at any time. Press the Stop button again to shut the power off immediately.

8.) Slide the CD Door OPEN switch to the right to open the door and remove your disc. Close the CD Door and return your disc to its protective storage case.

PLAY/PAUSE

ON DBBS OFF

VOLUME

STOP

OPEN

7

HD7100_ib_0422.p65

7

 

22/4/2002, 11:43