Emerson HF1160BS 00 Maintenance, Accessories, IMPORTANT CARE INSTRUCTIONS for your Ceiling Fan

SAFETY CABLE

CEILING

COVER

THREADED STUDS (2)

#8 LOCKWASHER

KNURLED KNOB

Figure 9

WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

16.Pass the end of the safety cable through the two cable clamps (supplied) (Figure 10). Pass the end of the safety cable through the eye screw and then back through the two cable clamps.

Maintenance

IMPORTANT CARE INSTRUCTIONS

for your Ceiling Fan

Periodic cleaning of your new ceiling fan is the only maintenance that is needed.

When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.

Abrasive cleaning agents are not required and should be avoided to prevent damage to finish.

WARNING

Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock.

Accessories

1.Ceiling Fan Controls (see store or catalog).

2.Downrod Extension Kits (see store or catalog).

EYE SCREW

Figure 10

TO FAN

CABLE CLAMP

WARNING

The use of any other control not specifically approved for this fan could result in fire, shock and personal injury.

WARNING

CAUTION: It is important to note the proper installation position of the cable clamps as illustrated in Figure 10. TO obtain maximum holding power, install U-bolt section of clip on dead or short end of cable and saddle on long end of cable. Improper installation reduces the efficiency of the connection by as much as 40 percent.

17.After verifying that the cable clamps are positioned properly on the safety cable, tighten the nuts on the U-bolts. Leave one or two inches of slack in the safety cable before tightening the nuts. Cut off the excess cable.

18.If a remote speed control is to be used, refer to the Owner’s Manual included with the control for proper installation and wiring.

19.After completing the installation, restore the power and test run the fan.

NOTE: When any solid state motor speed control is used, a humming noise may be present in the fan on low speed. This hum in no way affects the operation of the fan and is acceptable in most industrial installations.

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

6 U.L. Model No.: HF1160