BP7280, Olympia, KF100 7/31/06 10:57 AM Page 6
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tight- ened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 3) could result in the fan falling.
5. Reinstall the hanger ball (Figure 5) on the downrod as follows. Route the three 80” motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the
HAIRPIN CLIP
SETSCREWS
Figure 3
DOWNROD
CLEVIS
PIN
MOTOR COUPLING
setscrew in the hanger ball. A loose setscrew could create fan wobble.
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
3. Tighten the setscrews (Figure 3) securely while pulling up on the down- rod.
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
4. Make sure the grommet is properly installed in the coupling cover, then slide the coupling cover on the down- rod until it rests on the motor housing. Place the ceiling cover over the down- rod. Be sure that the ceiling cover and the coupling cover are both oriented correctly (Figure 4).
DOWNROD
CEILING
COVER
HANGER BALL
PIN
DOWNROD
SETSCREW | CEILING |
| COVER |
Figure 5
6. The fan comes with blue, black and white leads that are 80” long. Before installing the fan, measure up approxi- mately 6 to
7. Mount the fan blades to the blade flanges using three
COUPLING
COVER
Figure 4
!WARNING
To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balanc- ing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
6
