Emerson KF180 owner manual Operating Your Ceiling Fan, Installation of Storage Bracket

Models: KF180

1 16
Download 16 pages 3.18 Kb
Page 11
Image 11
Operating Your

BP7284, Sturbrige, KF180 7/31/06 10:52 AM Page 11

Installation ofManual background 9. Grasp the lower ring assembly and raise it up and over the ring rods of the adapter assemlby (Figure 16). Position the ring assembly of that the ring Manual background assembly arms protrude through the holes at the end of the ring rods. Secure the ring asembly in the ring rods using the six ring screws.

button is held down. When the light is at the desired brightness, release the button.

5.To turn the light on and off, press and

release the button. The light will turn on at the light level previously set (see step 4).

RING

 

SCREWS (6)

RING ROD

ARM

LOWER RING

ASSEMBLY

Figure 16

Manual backgroundManual background 10. Your ceiling fan is now installed and wired to be controlled by your remote control system.

Operating Your

Ceiling Fan

IMPORTANT

Fan installation must be completed, including the installation of the fan blades, before testing of the remote control.

Your remote control (Figure 17) has full control of your fan and light. However, air- flow direction is controlled by a slide switch on the switch housing.

Manual backgroundManual background 1. Restore electrical power to the outlet box by turning the electricity on at the service panel.

2. To set the desired fan speed, press the HI, MED, or LOW buttons to operate your fan on high, medium, or low speed (Figure 17).

3. To turn your fan off, press the OFF button.

Manual backgroundManual background 4. To set the level of light brightness,

press and hold the light button. The light brightness will continue to increase then decrease while the

MED LOW

HIOFF

STORAGE

BRACKET

Figure 17 Manual background

6.If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Then slide the reversing switch (Figure 18) to the opposite position and turn the fan on again. The blades will turn in the oppo- site direction and reverse the airflow.

REVERSING

SWITCH Manual background

Figure 18

Installation of

Storage Bracket

A storage bracket is supplied with the remote control for holding the transmitter when not in use. If you desire to use the bracket, use the two screws (supplied) and install it on a wall that is away from excess heat or humidity.

11

Page 11
Image 11
Emerson KF180 owner manual Operating Your Ceiling Fan, Installation of Storage Bracket