The fan comes with blue, black, and

BP7284, Sturbrige, KF180 7/31/06 10:52 AM Page 6

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tight- ened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 3) could result in the fan falling.

through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.

HAIRPIN CLIP

DOWNROD

MOTOR COUPLING

!WARNING

It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

SETSCREW (2)

Figure 3

6. The fan comes with blue, black, and

CLEVISwhite leads that are 80” long. Before

installing the fan, measure up approxi- mately 6 to 9-inches above top of hang- er ball/downrod assembly. Cut off excess leads and strip back insulation 1/2” from end of leads.

3. Tighten the setscrews (Figure 3) securely while pulling up on the down- rod.

NOTE: The setscrews must be properly installed as described above, or fan wobble could result.

4. Place the ceiling cover over the down- rod as shown in Figure 4.

PIN	HANGER BALL

CEILING

COVER

DOWNROD

SETSCREW

7.Mount the fan blades to the blade flanges using four 10-24 x 9mm truss head screws and four fiber washers (supplied) (Figure 5).

!WARNING

To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balanc- ing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

10-24 x 9mm