In the menu "Auxiliary lines" you can determine if the last four lines in the single component display of the current channel shall appear. If you want to set up the lines of the other channels of the joint analyzer modules, press the F3 key.

Set up parameters:

¨Select any line of variables or any menu line with the ↓ -key or the − -key.

¨Select the parameter with the ENTER key or the → -key.

¨Select "Enabled" or "Disabled" with the − -key or the ↓ -key to enable or disable the display of the corresponding auxiliary line in the single component display.

¨Confirm the parameter selected with the ENTER key or cancel and go back to the last adjustment with the F2 key.

Choose the source module for the auxiliary lines:

You will change via the line "First line source...", "Second line source...", "Third line source..." or "Last line source..." to the corresponding submenus. The tags of all modules combined with the platform or MLT analyzer are available:

CLD

 

 

 

95.0 ppm

 

First auxiliary line source

 

Select the module to use as source for this line

 

in the single analyzer display screen.

 

CLD

 

 

 

 

HOME

ESCAPE

MORE

BACK

INFO

F1

F2

F3

F4

F5

¨Go to the line you want with the − -key or the ↓ -key.

If there are more than eight source modules available you have to press the F3 key to go to another menu page.

¨Select the tag of the module with the ENTER key or the → -key: The display will go back to the menu "Auxiliary lines" automatically. The selection will be done.

Menu line "Units...":

From the menu "Main display configuration" you can change via the line "Units..." to the submenu "Units control":

6 - 6

NGA 2000

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98