II) V24/RS232/485 Interface - Single Analyzers and Systems

SNAB – Control command "Zerogas calibration"

Starting this command the analyzers in a system or the single analyzer will start a zerogas calibration. The calibration gas flow will start automatically and the calibration procedure will run. After this procedure will be over the system, the analyzer in a system or the single analyzer will change to the stand-by mode. The running calibration procedure can be canceled with the "STBY" command.

Control command

SNAB K0

Function associated to the whole system unit

Code

SNAB K1 Kn

Function associated to channel n

Function associated to channel 1

Code

Response

SNAB 0

Error status

Code

90003752(1) [AK-Commands] 10/98

AK

2 - 27