II) V24/RS232/485 Interface - Single Analyzers and Systems

SRES – Control command "Reset"

With this command the FU will get a software reset. This command has the same effect to the FU like the switching off and on of the power supply. All running procedures will be canceled. An initializing will be started, e.g. check and control of temperature setpoints. After that the operation modes "Manual" and "Stand-by" will be enabled.

Control command

SRES K0

Function associated to the whole system unit

Code

SRES Kn

Function associated to channel n

Code

Response

SRES 0

Error status

Code

90003752(1) [AK-Commands] 10/98

AK

2 - 33