Emerson Process Management warranty Electrical Wiring, HOW Your HOT Water Dispenser Works

HOW YOUR HOT WATER DISPENSER WORKS

Water is electrically heated to near-boiling (190˚F/88˚C) in a compact tank that mounts under the sink. A thermostat maintains it at this approximate temperature. When you turn the handle, cold water enters the tank and forces hot water out of the faucet. The system is vented so the tank is not pressurized.

Due to the unique operation of your instant Hot Water Dispenser, you may experience a slight delay in the dispensing of water after the handle is actuated. This assures maximum water temperature and is not indicative of a problem with the unit.

Important:

Do not install this appliance in public areas or institutions where there is unsupervised access to this appliance.

H-990 dispenser shown

VENT LINE

26" INCOMING

WATER SUPPLY LINE

16" MAXIMUM

FLEXIBLE

OUTLET

ADJUSTABLE

THERMOSTAT

SPECIFICATIONS

Capacity: 1/2 gallon (1.9L), up to 60 cups of 190˚F (88˚C) water per hour

Electrical: 750 watts, 6.5 amps, 115 volts A.C. Grounding 3-wire cord and plug provided

Thermostat: Snap-action, adjustable from 160˚F to 211˚F (71˚ to 99˚C). Factory pre-set at approximately 190˚F (88˚C)

Insulation: Meets UL 94HF-1 flammability specification

Valve: Rapid, self-closing

Shipping weight: 7 lbs. (3.2 kg.)

ELECTRICAL WIRING

Use this diagram if you are using the same wall outlet for the dispenser and your disposer.

Dispenser outlet must be independent of wall switch

wall switch

115 VAC line

Disposer outlet only is controlled by wall switch.