Emotiva UPA-2 Rear Panel Layout, RCA Audio Inputs/Outputs, Master Power Switch, Level Control

Rear Panel Layout

RCA Audio Inputs/Outputs

These inputs are for signal input

for each channel on the UPA-2. Simply connect the appropriate input to your preamplifier/processor or other preamp level audio device. Loop outputs and inputs are paralleled.

Master Power Switch

This rocker switch provides the master power for the UPA-2. After it is in the ON position, the amplifier can be turned on manually from the front panel switch or automatically with the trigger input via 3.5mm input jack.

Level Control

When set to Minimum,the amplifier has no output;when set to Maximum, it has 32dB of gain and will match the gain structure of all the other Emotive Amplifiers.(Note:Loop out is not controlled by it.)

Remote Turn On Jack (output)

Speaker Outputs (5 way Binding Posts)

These are the speaker outputs. The 5 way binding posts accept stripped speaker wire, banana plugs (single or dual), or spade connectors. Be sure to observe correct polarity when connecting speakers and be sure that the wires do not touch between positive and negative terminals.

.This 3.5mm jack accepts a +12 volt output for remote activation of the other device. This mates directly with the Emotiva products trigger in and supplied cable. If building your own cable, center is positive and outer shield is negative.

Remote Turn On Jack (input)

This 3.5mm jack accepts a 5-12 volt input for remote activation of the UPA-2. This mates directly with the Emotiva processor trigger out and supplied cable. If building your own cable, center is positive and outer shield is negative.

Power Receptacle

This is a standard IEC 2 prong power receptacle. It is advised that this amplifier have a direct connection to a wall outlet. Do not plug into a “power strip”.

Page 9