FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electrical switch;
do not use any phone in your building.
•Immediately call your gas supplier from a neigh- bor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control handle. Never use tools. If the handle will not push in or turn by hand, don't try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service techni- cian to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information above.
2.Set the thermostat to lowest setting.
3.Remove floor register.
NOTE: The gas control handle is attached to the gas control knob.
4.Push in gas control handle slightly and turn clock-
wise 
to "OFF."
NOTE: Handle cannot be turned from "PILOT" to "OFF" unless handle is pushed in slightly. Do not force.
5.Remove the pilot access cover located on the combustion chamber.
6.Wait ten (10) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above. If you don't smell gas, go to the next step.
7.Find pilot - the pilot is adjacent to the center portion of the main burner in the area directly below
3588 5088
the pilot access open-7088 ing.
8.Turn gas control handle counterclockwise 
to "PILOT."
9.Push and hold control handle in and repeatedly push the ignitor button until pilot is lit (or use match and lighter rod to light.) Continue to hold the control handle in for about one (1) minute after the pilot is lit. Release handle and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 4 through 9.
•If handle does not pop up when released, stop and immediately call a qualified service tech- nician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control handle to "OFF" and call your service technician or gas supplier.
10.Replace pilot access cover.
11.Turn gas control handle counterclockwise 
to "ON."
12.Replace floor register.
13.Set thermostat to desired setting.
TO TURN OFF GAS TO APPLIANCE 
1. | Set the thermostat to lowest setting. | 3. | Push in gas control handle slightly and turn | |
2. | Remove floor register. |
| clockwise | to "OFF." Do not force. |
|
|
| ||
|
| 4. | Replace floor register. | |
Page 7 |
