Empire Comfort Systems DV-55T-1 Important Safety Information, Vent KIT Information

IMPORTANT SAFETY INFORMATION

THIS IS A HEATING APPLIANCE

DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.

• Due to high temperatures the appliance should be located	excessive lint from carpeting, bedding materials, etc. It
out of traffic and away from furniture and draperies.	is imperative that control compartments, burners and
• Children and adults should be alerted to the hazards of	circulating air passageways of the appliance be kept
high surface temperatures and should stay away to avoid	clean.
burns or clothing ignition.	• DO NOT put anything around the furnace that will
• Young children should be carefully supervised when they	obstruct the flow of combustion and ventilation air.
are in the same room as the appliance.	• DOkeeptheapplianceareaclearandfreefromcombustible
• Clothing orotherflammable material should not be placed	material, gasoline and other flammable vapors and
on or near the appliance.	liquids.
• Any safety screen or guard removed for servicing an	• DO examine venting system periodically and replace
appliance must be replaced prior to operating the	damaged parts.
appliance.	• DO make a periodic visual check of pilot and burners.
• Keep burner and control compartment clean.	Clean and replace damaged parts.
• Vent cap hot while furnace is in operation.	• CAUTION: Pilot hole cover must be kept tightly closed
• Installation and repair should be done by a QUALIFIED	during operation.
	• DO NOT use this heater if any part has been under water.
SERVICE PERSON. The appliance should be inspected
before use and at least annually by a qualified service	Immediately call a qualified service technician to inspect
person. More frequent cleaning may be required due to	the heater and to replace any part of the control system
	and any gas control which has been under water.

VENT KIT INFORMATION

Attention: The DV-55T direct vent wall furnaces are provided with vent kit, DV4T-59-1 for wall depths of 5" to 9". For wall depths greater than 9", refer to Accessories, Page 6. Listed below are the vent kits.

Attention: The minimum wall depth for installation of a DV-55T MUST BE 5". If the wall depth is less than 5" you can order DV- 822, refer to Accessories, Page 6 or refer to Figure 10 and Figure 11 with accompanying text, Page 11.

13118-7-0408 Page 3