Empire Comfort Systems MS-200, SE-200, SE-300, MS-100, ES-S300 Sectional Parts for GAS Stove, 3088

SECTIONAL PARTS FOR GAS STOVE

SP-010	SP-011	SP-012		SP-064		SP-063 SP-065			SP-066
S-1111	S-1122	S-1133		S-1144		S-1155 S-1166			S-1177
SP-067	SW2-1		SW3-1	SP-013		SP-014 SP-015			P-220 P-219
S-1188				S-1211		S-1222	S-1233		S-1244 S-1255
SP--1266221	SP-034	RS--33371288	R-3445	SP--1300028		RS--33391 11		SP-1322-055	SP-062
	S-1277		S-1299						S-1333
		SSP-1366-016	S-1377		S-1380		S-1389

SP-010	One-Burner Top	SP-013	One-Burner Drip Pan	SP-028	Burner hanger
SP-011	Two-Burner Top	SP-014	Two-Burner Drip Pan	R-3339	Grate
SP-012	Three-Burner Top	SP-015	Three-Burner Drip Pan	SP-055	Round Burner
SP-076	One-Burner Semi-Enclosed Frame*	P-220	One-Hole Manifold	SP-062	Star Burner
SP-064	Two-Burner Semi-Enclosed Frame	P-219	Two Hole Manifold	SP-016	6" Low Leg
SP-063 Three Burner Semi-Enclosed Frame		P-221	Three Hole Manifold	S-1377	28" High Leg
SP-065	One-Burner Mini-Stove Frame	SP-034	Manifold Clamp	S-1380	32" High Leg
SP-066	Two-Burner Mini-Stove Frame	R-3337	Knob	S-1388	Leg Brace for 32" High
SP-067	Three-Burner Mini-Stove Frame	R-3445	Gas Valve	SW2-1	Two-Burner Windscreen
* Not Shown				SW3-1	Three-Burner Windscreen

WARNING: NEVER PUT HANDS OR
FACE
DIRECTLY OVER BURNER WHILE
LIGHTING
You may adjust valve setting at this time.
The flame should show a greenish
blue inner cone with a slight yellow BURNER
tip. If necessary, you can make an
adjustment by turning the hood of the LEG	SHUTTER
	AIR￿
valve in a counterclockwise direction
until the flame performance is
satisfactory. See other side for further in-
structions regarding valve setting.

GRATE		CAUTION: Orifice HOODS must again be turned down, if the gas
	STOVE
		stove is to be used on LP gas after it has once been adjusted for other
		gases.

MANIFOLD￿		GAS ENTRANCE
CLAMP
MANIFOLD
		DUST COVER
GAS￿	ADJUSTING PIN	STEM
VALVE
DRIP￿	HOLE IN￿
	ADJUSTING PIN
PAN
KNOB	ADJUSTING HOOD
	ADJUSTING HOOD￿ VALVE BODY

SHOULDER

DO not tamper with or attempt repairs on the burners, frames valves, or	UNDER NO CIRCUMSTANCES SHOULD ANY ALTERATIONS
LP cylinder. Allow only qualified LP Gas Dealers to make repairs and
	BE MADE TO THE GAS VALVE AND BURNER ASSEMBLY.
adjustments.
Always close LP cylinder valve after use. Always use and store bottle in	Warranty
an upright position. Never store or transport these cylinders in an
occupied enclosure.	Empire Comfort Systems, Inc. makes no claim of fitness of this prod-
Adjustment Instructions-Universal Gas Valve	uct for a particular purpose or use and assumes no liability for damages
Your portable gas stove is furnished with A.G.A. listed Universal type	resulting from the use of the product. Liability of the manufacturer in
Gas Valve. This valve is designed for use with (Liquefied Petroleum	any event is limited to the amount of the original purchase price of this
LPG), Natural or Manufactured Gas. When gas plate is installed the	product. This warranty applies only to the use of the product in
valve should be set for the kind of gas to be used.	accordance with the manufacturer's operating instructions, and remains
The universal valve is adjusted for the various gases by turning the	in force only so long as the product remains in its original
ADJUSTING HOOD. To turn HOOD use wrench on HOOD SHOUL-	configuration. This warranty does not apply to products that have been
DER. This may be done after gas stove is assembled as HOOD	altered or repaired by outside agents, abused, damaged through neglect,
SHOULDER is easily accessible.	misuse, or accident, or to products that have been used in any way other
1. This valve is shipped from the factory adjusted for LP gas. If LP gas	than in accordance with manufacturer's operating instructions. There
	are no other warranties, expressed or implied, pertaining to this product
is to be used, no adjustments should be necessary. Orifice HOOD
	or any other product sold by us. Empire Comfort Systems, Inc. neither
can be open slightly to get desired flame.
	assumes any responsibility in its behalf for operation of this or any
2. For use with Natural or Manufactured gas open HOOD until the
	other product manufactured or sold.
proper amount of gas is fed to each burner. When properly adjusted
the flame should have greenish blue inner cones about one-half inch
long. An unnecessary high flame is wasteful and inefficient.
3. The air shutter for each burner should be adjusted so the flame burns
clean without blowing. After you obtain the correct setting or the air

shutter, lock in place by tightening the air shutter screw.

Page 2	CAUTION: MAXIMUM WORKING PRESSURE 1/2 P.S.I. 11-INCH WATER COLUMN	R-3088
	(LOW PRESSURE REGULATOR IS REQUIRED)