Energy Tech Laboratories DSH General Safety Guidelines, safety symbols, Read Before Proceeding

FORM 145.32-IOM1 (908)

IMPORTANT!

READ BEFORE PROCEEDING!

GENERAL SAFETY GUIDELINES

This equipment is a relatively complicated apparatus. During installation, operation, maintenance or service, individuals may be exposed to certain components or conditions including, but not limited to: refrigerants, oils, materials under pressure, rotating components, and both high and low voltage. Each of these items has the potential, if misused or handled improperly, to cause bodily injury or death. It is the obligation and respon- sibility of operating/service personnel to identify and recognize these inherent hazards, protect themselves, and proceed safely in completing their tasks. Failure to comply with any of these requirements could result in serious damage to the equipment and the property in

which it is situated, as well as severe personal injury or death to themselves and people at the site.

This document is intended for use by owner-authorized operating/service personnel. It is expected that this individual possesses independent training that will en- able them to perform their assigned tasks properly and safely. It is essential that, prior to performing any task on this equipment, this individual shall have read and understood this document and any referenced materials. This individual shall also be familiar with and comply with all applicable governmental standards and regulations pertaining to the task in question.

safety symbols

The following symbols are used in this document to alert the reader to areas of potential hazard:

DANGER indicates an imminently haz- ardous situation which, if not avoided, will result in death or serious injury.

WARNING indicates a potentially haz- ardous situation which, if not avoided, could result in death or serious injury.

CAUTION identifies a hazard which could lead to damage to the machine, damage to other equipment and/or environmen- tal pollution. Usually an instruction will be given, together with a brief explana- tion.

NOTE is used to highlight additional in- formation which may be helpful to you.

All wiring must be in accordance with published specifications and must be performed only by qualified service personnel. Johnson Controls will not be responsible for damages/problems resulting from improper connections to the controls or application of improper control signals. Failure to follow this will void the manufacturer’s warranty and cause serious damage to prop- erty or injury to persons.

2 JOHNSON CONTROLS