12
| Parts |
| Description |
|
| LAN Ports (1 – 4) |
| Use an Ethernet cable to connect each port to a computer on your Local Area Network (LAN). |
|
| WAN Port |
| Use an Ethernet cable to connect this port to your WAN router. |
|
| Antenna Connector |
| Interface for the antennas. |
|
|
|
|
|
|
| LAN LED |
| This LED will light up once an Ethernet cable is connected to one of the LAN ports. |
|
| WAN LED |
| This LED will light up once an Ethernet cable is connected to WAN (Internet) port. |
|
| WLAN LED |
| This LED will light up once the RF (wireless LAN) feature is enabled |
|
| Power LED |
| This LED will light up once the power cable is connected to the DC connector. |
|
| WPS button |
| 1- 5 seconds: activates WPS |
|
|
|
|
| |
|
|
| 11~ seconds: reset to default |
|
| Power Switch |
| Turn on or off the device |
|
|
|
|
|
|
1.5. System Requirements
The following are the minimum system requirements in order configure the device.
PC/AT compatible computer with a Ethernet interface.
Operating system that supports HTTP
1.6.Applications
The wireless LAN products are easy to install and highly efficient. The following list describes some of the many applications made possible through the power and flexibility of wireless LANs:
a)Difficult-to-wire environments
There are many situations where wires cannot be laid easily. Historic buildings, older buildings, open areas and across busy streets make the installation of LANs either impossible or very expensive.
b)Temporary workgroups
Consider situations in parks, athletic arenas, exhibition centers,
12
