Installation
DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:
1.Check clearances to combustibles.
2.Do not obtain combustion air from an attic, garage or any unventilated space. Combustion air may be obtained from a ventilated crawlspace.
3.Do not install the stove in a bedroom.
4.You can vent the stove through an exterior wall behind the unit or connect it to an existing masonry or metal chimney (must be lined if the chimney is over 6” (15 cm) diameter, or over 28 inches² (180 cm²) cross sectional area). An interior vent can be used with approved pipe passing through the ceiling and roof.
5.Locate the stove in a large and open room that is centrally located in the house. This will optimize heat circulation.
6.The power cord is 8 feet (2.43 m) long and may require a grounded extension cord to reach the nearest electrical outlet.
REMOVING PELLET STOVE FROM PALLET:
1.Remove the right and left hand cabinet sides by loosening the three (3)
������ ��� ��� ���
���������� ���� ��
������ ���� �� ��� �����
�� ������ ��� ����
������� �������
2.Remove the one (1) screw located on the front of the cabinet side, behind the top louvers and one (1) screw behind the ash door.
3.Remove the two (2) wood screws that are holding the bottom of the stove to the pallet.
4.Close the side panels.
Figure 4: Screws to take out to remove stove from pallet.
11
