Once you are finished using the pellet appliance for the season, unplug the stove for added electrical protection. It is very important that the stove be cleaned and serviced as stated above. (See Section Areas of Routine Inspection)
5
4
2
3
1
ELECTRICAL COMPONENT FUNCTIONS
The following is a list of electrical components and their functions on the ENVIROFIRE
1.CONVECTION FAN CONTROLLER
This controller is responsible for varying the speed of the convection blower. Should the convection blower be set on low and
2.AUGER PULSE LIGHT
This light will flash in conjunction with the pulses to the auger.
3.START-UP SWITCH
When this momentary contact switch is pressed it will initiate the
4.DIAL-A-FIRE (HEAT OUTPUT CONTROL)
This unit is responsible for controlling the timing of the auger motor. When turned clockwise it will cause the OFF time between auger pulses to shorten, resulting in more heat output and pellet consumption. Turn the knob
5.CONVECTION BLOWER
This blower fan,(mounted on the right side of the stove) draws room air from the back of the stove and passes the air through the heat exchanger tubes and back into the room. The sealed system keeps the room air separate from the combustion air. The convection blowers fan controller controls this fan’s speed.
10