![](/images/new-backgrounds/1057024/5702429x1.webp)
MASONRY FIREPLACE INSERT INSTALLATION, MODEL FPI
The Fireplace Insert model includes surround face. (Surround assembly instructions are in this manual). (SEE PAGE 15 in this manual)
CLEARANCE TO COMBUSTIBLES: |
|
|
|
Side wall | 9” (200 mm) from the body of the heater | ||
Facing on masonry fireplace | 9” (200 mm) from the body of the heater | ||
Mantle | 8” (200 mm) from the body of the heater | ||
FIREPLACE INSERT SIZE: |
|
|
|
Width | 22” | (550 mm) | |
Height | 21 | 1/8”” | (537 mm) |
Depth | 20 | 9/16”” | (522 mm) |
-
1.
2.
3.
4.
5.
6.Install fresh air intake either through the back of the fireplace or through the positive flue connector. (This is optional) However this is recommended.
When installing the fireplace insert into a zero clearance fireplace, DO NOT cut or modify any factory firebox parts. If the fireplace insert does not fit into a zero clearance fireplace we recommend you use ENVIROFIRE model FS and install it as a hearth mount unit.
*NOTE: DO NOT remove the damper from the fireplace. Install a 3” (76 mm) stainless steel exhaust flex pipe from the stove to the top of the chimney
A
Install the hearth pad
Lock fireplace damper in the open position
Install positive flue connector at the fireplace dampers
Connect a Tee or a 90 degree elbow to the exhaust pipe
Install flexible stainless steel liner or listed pellet vent to the top of the chimney
15