PARTS AND ACCESSORIES
Service Parts available from your local Envirogas Dealer
Burner Control Assembly | Convection Blower |
Natural Gas Pilot Assembly | Light Bulb Holder |
Propane Pilot Assembly | Light Switch (momentary) |
Door Bolt | Fan Controller |
Relief Door Gasket | Log Set (with Embers) |
Regulating Valve | Thermocouple |
Piezo Igniter | Embers |
Burner Switch | Thermopile |
Door Gasket | |
Orifice Blank | Convection Fan Sensor 120 F (49C) |
Accessories
Gold trim Package
Low Voltage Thermostat
REMOVING or LUBRICATING THE BLOWER
The blower should be lubricated every 12 mos.
1. Turn the unit off and remove the log set.
2. Remove the burner tray assembly by removing the screw on either side of the tray, between the front and rear burners. Lift the tray out. Remove the brick liner by undoing the screw on either side and sliding the panel out.
3.Remove the
Use a light lubricating oil on screws before removal.
4.Carefully pull the blower assembly into the firebox, exposing the blower lubricating holes (located on the top of the motor housing on either side of the label). Add 2 drops of SAE 20 oil.
5.If removal of the blower is necessary, disconnect the blower leads from the harness. Remove the blower.
6.To
14
