EN-8500

ERROR MESSAGE & POSSIBLE SOLUTION

CABLE NOT CONNECTED :

1.Check that the signal-cable is properly connected , If the connector is loose, tighten the connector’s screws.

2.Check the signal-cable’s connection pins for damage.

INPUT NOT SUPPORT :

Your computer has been set to unsuitable display mode ,Set the computer to display mode given in the following table.

VIDEO/TV NO SIGNAL :

You set the monitor to the VIDEO /TV mode but there is no video/TV signal input. Check to make sure that the video/TV signal cable is properly connected and make sure the video player is working.

If the monitor is stuck in “Power Saving” mode:

1.Make sure monitor’s signal-cable is properly connected to the computer.

2.The computer has switched the monitor into power save mode. Press any key on the computer keyboard to wake up the monitor.

3.Check that the computer is switched on.

4.Check the computer resolution, rate may be too high and out of the LCD- MONITOR’s display mode range.

RESOLUTION :

RESOLUTION

VERTICAL

RESOLUTION

VERTICAL

FREQUENCY

FREQUENCY

 

 

640 × 480

60Hz

800 × 600

60.3Hz

 

 

 

 

640 × 350

70Hz

800 × 600

72.2Hz

 

 

 

 

720 × 400

70Hz

800 × 600

75Hz

 

 

 

 

640 × 480

72.8Hz

832 × 624

74.5Hz

 

 

 

 

640 × 480

75Hz

1024 × 768

60Hz

 

 

 

 

640 × 480

66.67Hz

1024 × 768

70Hz

 

 

 

 

800 × 600

56.3Hz

1024 × 768

75Hz

 

 

 

 

 

 

1024 × 768

74.92Hz

 

 

 

 

25