5

GENERAL NOTES
The following symptoms are normal with LCD monitor and do not indicate a problem.
• Due to the nature of the fluorescent light, the screen may flicker during initial use.
Turn off the Power Switch and then turn it on again to make sure the flicker
disappears.
• You may find slightly uneven brightness on the screen depending on the desktop
pattern you use.
• The LCD panel used in this monitor is a very high technology product with
2,359,296 thin film transistors giving you fine picture details. Occasionally, a few
non-active pixels may appear on the screen as a fixed point of red, green, blue,
white or black. Please note that this does not indicate a defective panel.
• Due to the nature of the LCD screen, an after-image of the previous screen may
remain after switching the image when the same image has been displayed for a
long time. The monitor will slowly recover from this.
• LCD monitors have a fixed size & number of pixels. Due to this, an interpolation
is necessary to operate the monitor in a resolution below its native resolution
which may slightly de-grade the display quality. Therefore, it is highly
recommended to operate this monitor at its native resolution of 1024x768 @
60Hz.

OTHER NOTES

• The screen surface is very soft. Do not rub, touch or tap the screen surface with
sharp object such as pen or pencil. This contact may scratch or damage the
screen. These damages are not covered under the warranty.
• Turn your computer OFF before installing your new monitor. Refer to your
computer manual for the proper shut down procedure.
• Save the original shipping carton and packing materials, as they will come in
handy if you ever have to ship your monitor.
• For maximum protection, repackage your monitor as it was originally packed at
the factory.
• To keep the monitor looking new, periodically clean the case & surface of the
TFT-LCD panel with a soft non-fibrous cloth lightly dampened with a glass cleaner.
Do not use any paper products to clean the screen. Never spay the glass
cleaner directly on the monitor. Never use strong solvents such as thinner,
benzene, or abrasive cleaners, since these will damage the case & panel. As a
safety precaution, always unplug the monitor before cleaning it.