8 |
Troubleshooting
Most difficulties in audio systems are the re- sult of poor or wrong connections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the con- trol settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the
Front Panel Power Indicator Is Not Lit
No main power to the
No Sound
If the amp is getting power, but is producing no sound, check the Protection indicator on the front panel. If it is lit, see below. If not, check all of your connections and control settings on associated components.
Protection Indicator Is Lit
The front panel indicator lights when the
Fuse Replacement
If everything checks out correctly and you still cannot get the amplifier to turn on, the inter- nal power fuse may have blown. If you be- lieve this has happened, contact your autho- rized Rotel dealer for information on where to take your amplifier to get the fuse replaced.
Specifications
Continuous Power Output | 120 watts/ch into 8 ohms | |
Dotal Harmonic Distortion | < 0.03% | |
Intermodulation Distortion (60 Hz : 7 kHz, 4:1) | < 0.03% | |
Frequency Response (+0.5 dB, | ||
Damping Factor | 180 |
|
Speaker Impedance | 4 ohms minimum | |
Signal to Noise Ratio (IHF A network) | 116 dB | |
Input Impedance/Sensitivity | 33 k Ohms/1.0 volt | |
Power Requirements | 115 | Volts, 60 Hz (U.S. version) |
| 230 | Volts, 50 Hz (European version) |
Power Consumption | 800 | Watts |
Dimensions (W x H x D) | 430 x 188 x 396 mm | |
| 1615/16 x 7 7/16 x 15 5/8 in | |
Weight (net) | 18 kg, 39.7 lb. |
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
THX and the THX logo are trademarks of Lucasfilm Ltd. All rights reserved.