Cleaning and Replacing the Air Filter

Clean the air filter on the bottom of the projector after every 100 hours of use. If it’s not cleaned periodically, it can become clogged with dust, preventing proper ventilation. This can cause overheating and damage the projector.

1.Turn off the projector and wait for the P power light to stop flashing.

2.Unplug the power cord and disconnect any cables.

3.Turn the projector over. Then use a small vacuum

cleaner designed for computers and other office equipment to clean the filter, as shown. If you don’t have one, gently clean the filter using a very soft brush (such as an artist’s camel-hair brush).

If the dirt is difficult to remove or the filter is broken, replace it. Contact your dealer or call Epson at (800) 873-7766 and ask for part number V13H134A04. In Canada, call (800) 463-7766 for dealer referral.

4. If you need to replace the filter, press the tab in and lift the cover up.

5. Remove the old filter and replace it with a new one.

6. To replace the cover, insert the tabs and press down until the cover clicks into place.

27