Epson 10600 Replacing the Maintenance Tank, Related Documentation

EPSON Stylus Pro 10600

8. Insert the new cutter.

9.Push down on the cutter’s side pin while turning the latch to the left.

10.Close the lower cover. The print head returns to the home position.

Replacing the Maintenance Tank

When the maintenance tank is nearly full, the printer displays the following message on the control panel:

MAINTENANCE REQ. 0100

You should call to schedule service at this point. When the waste ink system is at full capacity, the printer stops and displays the following message:

SERVICE REQ. 00000100

Approximately every two years of normal usage (25% duty cycle) or after 20,000 B0-size prints, you should have your authorized EPSON servicer replace the waste ink system. This is necessary to prevent damage to the print head and maintain print quality. Parts and labor for this service are not covered under the terms of the limited warranty.

You can monitor the status of the waste ink system by printing the status check sheet (see page 9); a low value (or a value near Empty) indicates that the pad is nearing the end of its service life.