Particular care should be taken when the projector is mounted on the ceiling, as small pieces of glass may fall down when the lamp cover is removed. Be very careful not to allow such pieces of glass to get into the eyes or mouth.
•Material or paper may get stuck against the air filter underneath the projector while it is in use. Remove anything from underneath the projector that might get stuck against the air filter in this way.
•Never try to remove the lamp immediately after use. Doing so will result in serious burns. Before remov- ing the lamp, turn off the power supply and wait approximately one hour to allow the lamp to cool completely.
•A mercury lamp with high internal pressure is used as the projector’s light source. Mercury lamps may make a loud noise when they break. Handle the lamp with extreme care while observing the following.
If the following points are not observed, injury or poisoning may result.
−Do not damage the lamp or subject it to any impacts.
−Do not use the lamp after the lamp replacement period has elapsed. Once the lamp replacement period has elapsed, the possibility of the lamp breaking becomes greater. When the lamp replace- ment message appears, replace the lamp with a new one as soon as possible.
−The gases inside mercury lamps contain mercury vapor. If the lamp breaks, immediately ventilate the room to prevent the gases that are released when the lamp breaks from being inhaled or com- ing into contact with the eyes or mouth.
−Do not bring your face close to the projector while it is in use, in order to prevent the gases that are released when the lamp breaks from being inhaled or coming into contact with the eyes or mouth.
−If the lamp breaks and needs to be replaced with a new lamp, contact Epson to carry out the replace- ment. If the lamp breaks, pieces of broken glass may get scattered around inside the projector.
−Particular care should be taken when the projector is mounted on the ceiling, as small pieces of glass may fall down when the lamp cover is removed. If cleaning the projector or replacing the lamp your- self, be very careful not to allow such pieces of glass to get into the eyes or mouth.
If the lamp breaks and gas from the lamp or frag- ments of broken glass are inhaled or get into the
eyes or mouth, or if any other ill effects are noticed, immediately seek medical advice.
•Consult your local, state, or federal regulations regarding proper disposal of the lamp and do not place in the trash.
•If there is an electrical storm, do not touch the power plug; otherwise you may receive an electric shock.
•If using a remote control that takes batteries, keep these batteries out of the reach of children. Batteries are choking hazards and can be very dangerous if swallowed.
If the batteries are swallowed, seek medical assis- tance immediately.
•When replacing batteries, take the following precau- tions.
−Replace the batteries as soon as they run out.
−If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets on your hands, wash imme- diately.
−Do not expose batteries to heat or flame.
−Dispose of used batteries according to local regulations.
−Remove the batteries if you won’t be using the pro- jector for a long period of time.
•Do not stand on the projector or place heavy objects on it.
WARNING: The cord included with this product contains chemicals, including lead, known to the State of Califonia to cause birth defects or other reproductive harm. Wash hands after handling. (Provided in accordance with Proposition 65 in Cal. Health & Safety Code §25249.5 et seq.)
65