Epson 36-075 Cutting Crown Moulding, Piece of crown moulding used for the inside

CUTTING

CROWN MOULDING

One of the many features of your saw is the ease of cutting crown moulding.The following is an example of cutting both inside and outside corners on 52/38 degree wall angle crown moulding. NOTE: When cutting 45 degree wall angle crown moulding, the following procedure for inside and outside corners is the same with the excep- tion that the bevel position will always be at 30 degrees and the miter position will be 35-1/4 degrees to the right or left.

1.	Move the table to the 31-5/8 degree right miter posi-
tion and lock the table in position. NOTE: A triangle indi-
cator is provided on the miter scale to find this angle
quickly.
2.	Tilt the saw blade to the 33-7/8 degree left bevel
position and tighten bevel lock handle. NOTE: A triangle
indicator is provided on the bevel scale to find this angle
quickly.
3.	Place the crown moulding on the table with the
CEILING EDGE of the moulding against the fence, and
make the cut, as shown in Fig. 39. NOTE: The piece of
crown moulding used for the outside corner will always
be on the right hand side of the blade, as shown at (A)
Fig. 39. The piece of crown moulding used for the inside
corner will always be on the left hand side of the blade,
as shown at (B) Fig. 39.
4.	To make the matching halves of the inside and out-

B

A

Fig. 39

D

C

Fig. 40

side corners, simply rotate the table to the 31-5/8

degree left miter position and tighten table lock handle.

NOTE: A triangle indicator is provided on the miter scale

to find this angle quickly.

5. Place the crown moulding on the table with the

WALL EDGE of the crown moulding against the fence

and make the cut. Again, the piece of crown moulding

used for the outside corner will always be on the right

side of the blade, as shown at (C) Fig. 40. The piece of

crown moulding used for the inside corner will always be

on the left side of the blade, as shown at (D) Fig. 40.

C

A

6.	Fig. 41, illustrates the two outside corner pieces; (A)
being the piece cut at (A) Fig. 41, and (C) being the piece
cut at (C) Fig. 41.
7.	Fig. 42, illustrates the two inside corner pieces; (B)
being the piece cut at (B) Fig. 42, and (D) being the piece
cut at (D) Fig. 42.

Fig. 41

B

D

Fig. 42

16