Epson Stylus Pro 4000

11.When done, press the Pause button to exit the head alignment mode.

If you want to verify or fine-tune the automatic alignment process, you can perform a manual head alignment. See your electronic Reference Guide for instructions.

Replacing the Cutter Blade

If you notice that your paper isn’t cut cleanly, the cutter blade may need to be replaced. For a list of media that do not work with the cutter, see the Printer Guide.

Make sure that the printer is on and the front cover is closed.

1.Press the Menu .

2.Press until you see MAINTENANCE, then press

Menu again. You see CUTTER REPL.

3.Press Menu to display EXEC.

4.Press Menu again. The print head moves to the replacement position. OPEN TOP COVER is displayed.

5.Open the top cover.

6.

7.When REPLACE CUTTER is displayed on the LCD, hold down the side pin as shown and turn the latch to the right.

8. Release the side pin and carefully remove the cutter blade.

WARNING: The blade is sharp. Be careful when removing it.

9. Insert the new cutter as shown.

10 - Epson Stylus Pro 4000

4/04