Stylus Color Service Manual

Disassembly and Assembly

3.1 OVERVIEW

This section describes the procedures for disassembling the main components of this printer.

Unless otherwise specified, the disassembled unit or components can be reassembled by reversing

the disassembly procedure. Therefore no assembly procedures are included. Precautions for any

disassembly or assembly procedure are described under the heading “Disassembly/Assembly

Points.” Adjustments required after assembling the unit are described under the heading “Required

Adjustments.”

3.1.1 Precautions for Disassembling the Printer

See the precautions below when disassembling the printer.

H Disconnect the power cable before disassembling or assembling the printer.

W Wearprotectivegoggles to protect your eyesfiom ink. Ifinkgets in your eye, flush your eye

un”thfiesh water and see a doctor immediately.

If ink comes into contact with your skin, wash it ofl with soap and water. If irm”tation

occurs, contact a physician.

■ A lithium battery is installed on the C137MXN board of this printer. Be sure to obseme

the follom”ng instructions when servicing the battery:

L Keep the battery away from any metal or other batteries so that electrodes of opposite

polarity do not come in contact with each other.

2. Do not heat the battery or put it near fire.

3. Do not solder on any part of the battey. (Doing so may result in leakage of electrolyte

from the battey, burning, or explosion. The leakage may afiect other devices close to the

battey.)

4. Do not change the battery. (An explosive gas may be generated inside the battery, and

cause burning or explosion.)

5. Do not dismantle the battery. (The gas inside the battey may hurt your throat. Leakage,

burning, or explosion may also result.)

6. Do not install the battey in the wrong direction. (This may cause burming or e~losion.)

■ Never remove the ink cati”dgefiom the carriage unless specified to do so.

H When transporting theprinter afler installing the ink cartridge, be sure to pack the printer

for transportation without removing the ink cartridge.

H Use only recommended tools fordisassembling, assembling, oradjusting the~”nter.

W Apply lubricants and adhesives as specifid. (See Chapter 6.)

W Make specij?ed adjustments when you disassemble the printer. (See Chapter 4.)

H There is a danger of explosion if the battey is notreplaced correctly. Replace only zm”th the

same or equivalent type recommended by the manufuturer. Dispose of used batteries

according to laws and regulations.

Rev. A

3-1

Page 64
Image 64
Open full-size image