EPSON PhotoPC 500
2. Grasp the cover and pull away.
3.Place the module into the socket, as shown below. Align the side of the module that has two notches with the socket end nearest the small black lever. (See the illustration under “Removing a PhotoSpan Memory Module” for the location of the lever.)
4.Press down on the module until it snaps into the retaining clips at the side of the socket. Do not force the module. If it does not seem to fit, make sure that you have inserted it correctly.
5.Replace the cover on the camera body. It should snap into place.
The number on the control panel indicating pictures remaining increases to show your camera’s expanded capacity.
With the expanded memory, you may notice a delay between the time you press the shutter button and when the camera beeps. To reduce this delay, press the button down halfway until you are ready to take the picture, then press it down the rest of the way.
Removing a PhotoSpan Memory Module
Follow these steps to remove the memory module:
CAUTION
Do not remove and install the module repeatedly. Doing so may cause a bad connection or may damage the memory module.
Turn the camera off and remove the memory module cover.
Press the lever on the side of the memory module socket to raise the module slightly out of the socket.
Grasp the edges of the memory module and work it up and out of the socket. Be careful not to touch the metal parts of the module.
Replace the memory module cover.
Digital Camera | 10/96 | EPSON PhotoPC 500 - 7 |