Epson PowerLite 62c/82c Projector

2.Turn the projector upside-down and clean the air filter and air intake vent. Epson recommends using a small vacuum cleaner designed for computers and other office equipment. If you don’t have one, gently clean them using a very soft brush (such as an artist’s brush).

Air vent

Air filter

If dirt is difficult to remove or the filter is torn, replace it. The air filter set (part number V13H134A08) contains two filters. See page 14 for ordering information.

3. If you need to replace the filter, slide it off, as shown.

4.Align the new filter carefully and slide it in until it clicks into place.

Replacing the Lamp

The projection lamp typically lasts for about 2000 hours of use (in high brightness mode) or 3000 hours (in low brightness mode). It is time to replace the lamp when:

❏The projected image gets darker or starts to deteriorate.

❏The Lamp light is flashing orange.

❏The message Replace the Lamp appears on the screen when the lamp comes on. To maintain projector brightness and image quality, replace the lamp as soon as possible.

See page 14 for ordering information and request part number V13H010L34.

Note:

You can check to see how many hours the lamp has been used using the Info menu. See your on-screen User’s Guide for instructions.

Follow these steps to replace the lamp:

1.Press the P Power button twice to turn off the projector. When you hear the projector beep twice, unplug the power cord.

2.If the projector has been on, allow it to cool down for at least an hour (or until the lamp is cool).

Warning:

Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury.

3.Use the screwdriver included with the replacement lamp to loosen the screw holding the lamp cover on top of the projector. Then slide the cover out and lift it off.

4.Use the screwdriver to loosen the two screws holding the lamp in place. (You can’t remove the screws.)

Loosen these screws

12 - Epson PowerLite 62c/82c Projector

9/05