Epson PowerLite 62c/82c Projector

Adjusting the Image

The following sections describe how to adjust the displayed image.

Adjusting the Height of the Image

If the image is too low, you can raise it by extending the projector’s front foot.

1.Stand behind the projector. Press the foot release button and lift the front of the projector. This unlocks the foot.

2.Raise the projector until the image is positioned where you want it, then release the button to lock the foot in place.

3.If you need to straighten the image, rotate the foot in the back of the projector to raise or lower the side.

If the image is no longer rectangular after raising it, see “Adjusting the Image Shape” in the next column.

Focusing the Image

Rotate the focus ring to sharpen the image.

Focus ring

Note: If a computer image is still out of focus, you can increase the clarity by pressing the Auto button on the remote control.

Rotate the zoom ring to reduce or enlarge the image.

Zoom ring

You can also change the image size by moving the projector closer to or farther away from the screen. You can use the E-Zoombuttons on the remote control to zoom in on a portion of the image, as described on page 8.

Correcting Computer Images

If you’ve connected a computer and the image doesn’t look right, or it doesn’t fit properly on the screen, press the Auto button on the remote control. This automatically resets the projector’s tracking, sync, resolution, and position settings. You must be projecting a computer image for this button to have any effect. Additionally, if the Auto Setup option in the Signal menu is set to OFF, the Auto function will not work.

Adjusting the Image Shape

The projector automatically corrects images that are distorted when the projector is tilted up or down (up to a 30° tilt). The Keystone window appears on the screen while the projector makes the correction. If the projected image still isn’t rectangular or has a “keystone” shape, do one or more of the following:

❏If your image looks like or , you’ve placed the projector off to one side of the screen, at an angle. Move it directly in front of the center of the screen, facing it squarely.

❏If your image looks like or , the Auto Keystone feature may have been disabled or you may need to manually adjust the keystone correction value. (Auto Keystone is not available when you’re using ceiling or rear projection.) Follow the steps below:

❏To turn on Auto Keystone, press the Menu button on the remote control. Use the pointer button on the remote control (or the arrow buttons on the projector) to select the Settings menu, then press Enter. If Auto

Keystone is OFF, use the pointer button to highlight this option and press Enter. Select ON in the Auto Keystone window that appears and press Enter to save your changes. Exit the menu by pressing Menu button.

9/05

Epson PowerLite 62c/82c Projector - 7