Epson PowerLite 62c/82c Projector
5. Hold the lamp as shown and pull it straight out.
Note:
The lamp(s) in this product contain mercury. Please consult your state and local regulations regarding disposal or recycling. Do not put in the trash.
6.Gently insert the new lamp. If it doesn’t fit easily, make sure it’s facing the correct way.
Caution:
Do not touch the glass portion of the lamp assembly. Touching the glass could result in premature lamp failure.
7.Once the lamp is fully inserted, tighten its screws.
Note:
Be sure to seat the lamp fully and secure the lamp cover. If the lamp is not properly installed or the cover is loose, the lamp will not turn on.
8.Lower the lamp cover into place. Then slide the cover closed and tighten the screw.
9. Reset the lamp timer as described on page 13.
Resetting the Lamp Timer
You must reset the lamp timer after replacing the lamp to clear the Replace the Lamp warning message. Follow these steps:
Note:
Do not reset the lamp timer if you have not replaced the lamp. If you do, the Lamp Hours will not accurately reflect the number of hours that the lamp has been used.
1.Connect the power cable and turn on the projector.
2.Press the Menu button on the remote control or projector and select the Reset menu. Then press Enter. You see the following:
3.Select the Reset Lamp Hours option and press Enter. You see the following:
4.Select Yes and press Enter.
5.Press Esc to return to the main menu or Menu to exit the menu system.
9/05 | Epson PowerLite 62c/82c Projector - 13 |