Light state | Cause and solution | |||
|
|
|
|
|
|
|
| Warning light is red | The projector is too hot, which turns off the lamp automatically. |
|
| |||
|
|
| ||
|
|
|
| Let it cool for five minutes, then turn it back on. Make sure there |
|
|
|
| is plenty of space around and under the projector for ventilation. |
|
|
|
| Also, clean or replace the filter if necessary (see page 48). |
|
|
|
| If you are using the projector at an altitude above 4900 feet (1500 |
|
|
|
| meters), turn on High Altitude Mode so the fan can properly cool |
|
|
|
| the projector at the high altitude air pressure (see page 46). |
|
|
|
|
|
|
|
| Warning light is | The lamp needs to be replaced (see page 50). Make sure you |
|
|
| ||
|
|
| ||
flashing red at | have a spare lamp handy. Check to make sure the lamp and lamp | |||
intervals | cover are securely installed. | |||
|
|
|
|
|
|
|
| Warning light is | There is an internal problem. Turn off the power switch on the |
|
|
| ||
|
|
| ||
flashing red at | back of the projector, and unplug it from the electrical outlet. | |||
intervals | Then contact Epson for assistance (see page 60). | |||
|
|
|
|
|
Solving Picture Problems
You cannot turn on the projector.
■Make sure the power cord is connected and the power switch is turned on. Then wait a moment for the power light to turn orange before pressing the P Power button.
■If you’ve set the Operation Lock, the control panel buttons are disabled; you must use the remote control to turn on the projector (see page 31).
No picture appears on the screen or you see the No Signal message displayed.
■Press the Source button on the projector or one of the Source buttons on the remote control to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.
■Press the Blank button on the remote control to make sure the picture hasn’t been turned off temporarily.
■Check that the P power light is green, not flashing, and the lens cover is off.
■The projector may be in standby (or sleep) mode. If the P power light is orange, press the Power button to turn the projector back on.
■Make sure your video equipment is turned on.
■Make sure your cable(s) are connected correctly (see page 18).
56 Problem Solving