The Image Off light is orange and the light is green.

Press on the remote control or control panel to turn the lamp back on.

The warning light is flashing orange.

High-speed cooling is in process. If MovieMate gets too hot again, projection stops automatically. Make sure MovieMate is at least 8 inches away from the wall.

Clean or replace the air filters if necessary (see page 46). If you are using MovieMate at an altitude above 4,900 feet (1500 meters), turn on High Altitude Mode (see page 44).

The warning light is flashing orange or red.

The lamp needs to be replaced. See page 48.

The button is flashing orange and green and the warning light is red.

MovieMate is too hot and has turned off the lamp. Make sure MovieMate is at least 8 inches away from the wall.

Clean or replace the air filters if necessary (see page 46). If you are using MovieMate at an altitude above 4,900 feet (1500 meters), turn on High Altitude Mode (see page 44).

Let MovieMate cool for five minute. When the Image Off light turns orange, press to turn the lamp on. If the status doesn’t change, wait a few minutes, then unplug MovieMate and contact Epson. See page 59.

The button is flashing orange and green and the warning light is flashing red.

The lamp may be incorrectly installed, the lamp cover may be loose, or the lamp may be broken. Turn off the power and check the lamp. See page 48. If the lamp is broken, or the lights continue to flash after you turn the power back on, unplug MovieMate and contact Epson. See page 59.

The button is flashing orange and green and the warning light is flashing red.

MovieMate has a problem with its fan or temperature sensor. Wait a few minutes, then unplug MovieMate and contact Epson. See page 59.

Problem Solving 53