20
Chapter 3: Platen and Cover Installation
•The JetPlate 7600 is now ready for the Platen.
1.Remove the roll of paper from the JetPlate 7600.
2.Open the roll cover.
3.Remove the 2 screws securing the black (left) spindle support and remove the support (1
upper (rear) and 1 lower (front)).
4.Remove the 3 screws from the white (right) spindle support and remove the spindle support (1 upper (rear), 1 lower (front), and 1 middle).
5.In the hardware kit, you will find four large headed screws two thick and two thinner.
6.Screw the two thinner screws into the two holes closest to the front of the printer (the lower holes from the spindle supports)(leave these screws fairly loose as the Platen brackets have to slide over these screws).
7.Screw the thicker two screws into the upper holes from the spindle supports, and tighten them down.
8.Attach the top cover to the Platen with the screws provided.
9.Place the Platen on the
JetPlate by sliding the Platen brackets down over the lower 2 screws from the spindle supports.
10.Place a large washer on each of the long screws and screw into the large holes in the Platen brackets.
11.Tighten ALL the Platen screws.
12.Slide the lower catch tray cover assembly into the brackets protruding from the lower front of the JetPlate, and secure with the
screws provided.
13.Align the paper guide cover with the paper guide and remove the screws from the paper guide that line up with the cover.
14.Attach the paper guide cover with the screws you removed from the paper guide.
All Trademarks used in this document are the properties of their respective owners. | Rev. 1.3 4/6/2004 |