6
Chapter 2: Setting up the JetPlate 7600
Unpacking and Assembling the Optional Stand
The JetPlate is shipped in two boxes: the JetPlate box and the Platen box. If you ordered the optional stand, you will have a third box.
Skip this step if you did not order the optional stand.
1.Unpack the optional stand if ordered, and make sure you have all these items. You will also need a Phillips screwdriver.
Parts:
A:Base, right and left (1 each)
B:Leg, right and left (1 each)
C:Bottom support bar (1)
D:Top support bar (1)
E:Basket hooks (4)
F:Basket (1)
Accessories:
G:Allen wrench (1)
H:Bolts (4)
I:Bolts (2)
J:Collars (2)
K:Phillips screws with washers (4)
L:Wing screws (2)
M:Washers (2)
for attaching lower bar to legs for attaching legs to base for attaching lower bar to legs
for attaching top support bar to legs for attaching printer to stand
for attaching printer to stand
2.Insert one of the legs into the base as shown. (The bolt holes line up only if the leg is matched with the correct base.) Use the included Allen wrench to fasten the leg with two bolts (H).
All Trademarks used in this document are the properties of their respective owners. | Rev. 1.3 4/6/2004 |