159
Maintaining and Transporting the Printer |159
•To run a super strong cleaning cycle, press d to highlight
SS CLEANING, then press r to display EXECUTE. Press OK to
start the cleaning cycle.
•To return all control panel settings to their default values, press d to
highlight DEFAULT PANEL, then press r to display EXECUTE.
Press OK to restore the default settings.
4. To exit maintenance mode, turn off the printer by pressing the PPower
button. Press the PPower button again to turn on the printer in the
normal operating mode.
Replacing the Paper Cutter
If you notice that your paper isn’t being cut cleanly, the cutter may need to
be replaced.
You can obtain a new cutter from Epson (part number C12C815331). See
page 12 for ordering details.

Removing the Old Cutter

Make sure the printer is turned on, then follow these steps to remove the
cutter:
1. Press r Menu.
2. Press d until MAINTENANCE is highlighted, then press r.
3. Press d until CUTTER REPLACEMENT is highlighted, then press r
again.
4. Press OK. The paper cutter moves to the replacement position.
Note: If the optional
SpectroProofer is
attached to the printer,
remove it following the
instructions that came
with it.