49
Setting Up the Printer |49
2. Plug the interface cable into the appropriate port on the printer.
3. Plug the other end of the cable into the appropriate connector on your
computer, or network switch or hub.
Installing the Software for Macintosh
Follow the steps below to install the software on a Macintosh. For Windows,
see page 50.
1. Make sure that your computer and printer are turned on and that the
Epson Stylus Pro 7890 or Pro 9890 is connected to the computer.
2. Insert the printer software CD-ROM in your CD or DVD drive.
3. Double-click the Epson icon.
4. Click the Epson Stylus Pro 7890 (or 9890) icon.
Network connection
USB connection
Note: You can check for a
newer version of your
printer driver on the Epson
support site at
www.epson.com/support.
Note: If you see the
message that the installer
has detected an older
version of EpsonNet
Config on your system,
you must uninstall the old
version before you can
install the new one. To
uninstall, drag the
EpsonNet folder to the
trash. Then reinstall your
printer software.