Once you have set the top of form, each time you finish printing a document, push the ON/OFF LINE button to put the printer offline and then push the FORM FEED button once to advance the paper one sheet. This enables you to tear off your just-printed pages and leave th paper in the correct position to begin the next document.

Note

Make sure that the front lid is in place whenever you print. (Always snap the lid shut when replacing the lid.) The front lid doubles as a paper bail, holding the paper against the platen.

Removing the tractor unit

It is necessary to remove the tractor unit before you use single-sheet paper. To remove the unit, follow these steps:

1.Remove the front lid.

2.Open the pin feed covers and pull the paper off the pins. Then lay the paper over the front of the printer so you can reach the tractor feed unit.

3.Grasp both sides of the tractor unit and gently lift up the front end. This action unsnaps the front legs of the tractor unit and enables you to lift off the unit.

4.Pull the paper guide toward you until it settles into an upright position for single-sheet paper.

5.Make sure that the paper release lever is forward, and remove the paper.

6.Replace the front lid.

Using Single-sheet Paper

The automatic loading feature handles individual sheets quickly and easily.

Before you load single-sheet paper, you must prepare the printer by installing the paper guide in an upright position. If the tractor unit is installed, remove it by following the above instructions. After following those instructions, you can skip the following section on paper guide installation, except for step 3 on aligning the left edge guide.

Setting Up

1.15