Epson AVR-687 13

Easy Setup Procedure

<POWER> <SPEAKER> <SETUP MIC> D H F G

[ON/SOURCE]

D H F G

[MODE SELECTOR 1]

D H F G

About the button names in this explanation

<> : Buttons on the main unit

[	] : Buttons on the remote control unit

Button name only :

Buttons on the main unit and remote control unit

Auto Setup

The AVR-687’s auto setup use the attached microphone to measure the acoustic properties in the room and automatically make the optimum settings.

• To make the sound field settings manually ( page 45 ~ 47).

qConnecting a microphone

1Connect the attached setup microphone to <SETUP MIC>.

Sound receptor

2 Mount the setup microphone on a camera tripod, etc., and set with the receptor pointing towards the ceiling.

Microphone

Place the setup microphone’s sound receptor at the height of the ears in the listening position.

It is not possible to measure properly if there are any obstacles between the speakers and microphone. Check that there are no obstacles.

ENGLISH

Easy Setup Procedure

w Before performing the Auto Setup procedure

1 Turn on your subwoofer.

Set the volume to halfway and set the crossover frequency to the maximum or Low pass filter off if your subwoofer can adjust the output volume and the crossover frequency.

Some subwoofers have a standby mode. Be sure to turn this function off before performing the Auto Setup procedure.

2 Turn on your monitor.

3 Press <POWER>.

¢ON:

The power indicator lights red.

£OFF:

The power turns off and the indicator is off.

4 Press <ON/STANDBY> or [ON/SOURCE].

• The power indicator blinks green and the power turns on.

5 Set [MODE SELECTOR 1] to “AUDIO”.

• Auto Setup mode is not displayed when using headphones.

eSwitching the front speaker

Press <SPEAKER> to select the front speaker (Front A, Front B or Front A+B).

ENGLISH